diff options
Diffstat (limited to 'drivers/net/wireless/bcmdhd/include/usbrdl.h')
-rw-r--r-- | drivers/net/wireless/bcmdhd/include/usbrdl.h | 203 |
1 files changed, 203 insertions, 0 deletions
diff --git a/drivers/net/wireless/bcmdhd/include/usbrdl.h b/drivers/net/wireless/bcmdhd/include/usbrdl.h new file mode 100644 index 00000000000..c90dccdcfad --- /dev/null +++ b/drivers/net/wireless/bcmdhd/include/usbrdl.h @@ -0,0 +1,203 @@ +/* + * Broadcom USB remote download definitions + * + * Copyright (C) 2012, Broadcom Corporation + * All Rights Reserved. + * + * This is UNPUBLISHED PROPRIETARY SOURCE CODE of Broadcom Corporation; + * the contents of this file may not be disclosed to third parties, copied + * or duplicated in any form, in whole or in part, without the prior + * written permission of Broadcom Corporation. + * + * $Id: usbrdl.h 296577 2011-11-16 03:09:51Z $ + */ + +#ifndef _USB_RDL_H +#define _USB_RDL_H + +/* Control messages: bRequest values */ +#define DL_GETSTATE 0 /* returns the rdl_state_t struct */ +#define DL_CHECK_CRC 1 /* currently unused */ +#define DL_GO 2 /* execute downloaded image */ +#define DL_START 3 /* initialize dl state */ +#define DL_REBOOT 4 /* reboot the device in 2 seconds */ +#define DL_GETVER 5 /* returns the bootrom_id_t struct */ +#define DL_GO_PROTECTED 6 /* execute the downloaded code and set reset event + * to occur in 2 seconds. It is the responsibility + * of the downloaded code to clear this event + */ +#define DL_EXEC 7 /* jump to a supplied address */ +#define DL_RESETCFG 8 /* To support single enum on dongle + * - Not used by bootloader + */ +#define DL_DEFER_RESP_OK 9 /* Potentially defer the response to setup + * if resp unavailable + */ + +#define DL_HWCMD_MASK 0xfc /* Mask for hardware read commands: */ +#define DL_RDHW 0x10 /* Read a hardware address (Ctl-in) */ +#define DL_RDHW32 0x10 /* Read a 32 bit word */ +#define DL_RDHW16 0x11 /* Read 16 bits */ +#define DL_RDHW8 0x12 /* Read an 8 bit byte */ +#define DL_WRHW 0x14 /* Write a hardware address (Ctl-out) */ +#define DL_WRHW_BLK 0x13 /* Block write to hardware access */ + +#define DL_CMD_RDHW 1 /* read data from a backplane address */ +#define DL_CMD_WRHW 2 /* write data to a backplane address */ + +#ifndef LINUX_POSTMOGRIFY_REMOVAL +#define DL_JTCONF 0x15 /* Get JTAG configuration (Ctl_in) + * Set JTAG configuration (Ctl-out) + */ +#define DL_JTON 0x16 /* Turn on jtag master (Ctl-in) */ +#define DL_JTOFF 0x17 /* Turn on jtag master (Ctl-in) */ +#define DL_RDRJT 0x18 /* Read a JTAG register (Ctl-in) */ +#define DL_WRJT 0x19 /* Write a hardware address over JTAG (Ctl/Bulk-out) */ +#define DL_WRRJT 0x1a /* Write a JTAG register (Ctl/Bulk-out) */ +#define DL_JTRST 0x1b /* Reset jtag fsm on jtag DUT (Ctl-in) */ + +#define DL_RDJT 0x1c /* Read a hardware address over JTAG (Ctl-in) */ +#define DL_RDJT32 0x1c /* Read 32 bits */ +#define DL_RDJT16 0x1e /* Read 16 bits (sz = 4 - low bits) */ +#define DL_RDJT8 0x1f /* Read 8 bits */ + +#define DL_MRDJT 0x20 /* Multiple read over JTAG (Ctl-out+Bulk-in) */ +#define DL_MRDJT32 0x20 /* M-read 32 bits */ +#define DL_MRDJT16 0x22 /* M-read 16 bits (sz = 4 - low bits) */ +#define DL_MRDJT6 0x23 /* M-read 8 bits */ +#define DL_MRDIJT 0x24 /* M-read over JTAG (Ctl-out+Bulk-in) with auto-increment */ +#define DL_MRDIJT32 0x24 /* M-read 32 bits w/ai */ +#define DL_MRDIJT16 0x26 /* M-read 16 bits w/ai (sz = 4 - low bits) */ +#define DL_MRDIJT8 0x27 /* M-read 8 bits w/ai */ +#define DL_MRDDJT 0x28 /* M-read over JTAG (Ctl-out+Bulk-in) with auto-decrement */ +#define DL_MRDDJT32 0x28 /* M-read 32 bits w/ad */ +#define DL_MRDDJT16 0x2a /* M-read 16 bits w/ad (sz = 4 - low bits) */ +#define DL_MRDDJT8 0x2b /* M-read 8 bits w/ad */ +#define DL_MWRJT 0x2c /* Multiple write over JTAG (Bulk-out) */ +#define DL_MWRIJT 0x2d /* With auto-increment */ +#define DL_MWRDJT 0x2e /* With auto-decrement */ +#define DL_VRDJT 0x2f /* Vector read over JTAG (Bulk-out+Bulk-in) */ +#define DL_VWRJT 0x30 /* Vector write over JTAG (Bulk-out+Bulk-in) */ +#define DL_SCJT 0x31 /* Jtag scan (Bulk-out+Bulk-in) */ + +#define DL_CFRD 0x33 /* Reserved for dmamem use */ +#define DL_CFWR 0x34 /* Reserved for dmamem use */ +#define DL_GET_NVRAM 0x35 /* Query nvram parameter */ + +#define DL_DBGTRIG 0xFF /* Trigger bRequest type to aid debug */ + +#define DL_JTERROR 0x80000000 +#endif /* LINUX_POSTMOGRIFY_REMOVAL */ + +/* states */ +#define DL_WAITING 0 /* waiting to rx first pkt that includes the hdr info */ +#define DL_READY 1 /* hdr was good, waiting for more of the compressed image */ +#define DL_BAD_HDR 2 /* hdr was corrupted */ +#define DL_BAD_CRC 3 /* compressed image was corrupted */ +#define DL_RUNNABLE 4 /* download was successful, waiting for go cmd */ +#define DL_START_FAIL 5 /* failed to initialize correctly */ +#define DL_NVRAM_TOOBIG 6 /* host specified nvram data exceeds DL_NVRAM value */ +#define DL_IMAGE_TOOBIG 7 /* download image too big (exceeds DATA_START for rdl) */ + +#define TIMEOUT 5000 /* Timeout for usb commands */ + +struct bcm_device_id { + char *name; + uint32 vend; + uint32 prod; +}; + +typedef struct { + uint32 state; + uint32 bytes; +} rdl_state_t; + +typedef struct { + uint32 chip; /* Chip id */ + uint32 chiprev; /* Chip rev */ + uint32 ramsize; /* Size of RAM */ + uint32 remapbase; /* Current remap base address */ + uint32 boardtype; /* Type of board */ + uint32 boardrev; /* Board revision */ +} bootrom_id_t; + +/* struct for backplane & jtag accesses */ +typedef struct { + uint32 cmd; /* tag to identify the cmd */ + uint32 addr; /* backplane address for write */ + uint32 len; /* length of data: 1, 2, 4 bytes */ + uint32 data; /* data to write */ +} hwacc_t; + +/* struct for backplane */ +typedef struct { + uint32 cmd; /* tag to identify the cmd */ + uint32 addr; /* backplane address for write */ + uint32 len; /* length of data: 1, 2, 4 bytes */ + uint8 data[1]; /* data to write */ +} hwacc_blk_t; + +#ifndef LINUX_POSTMOGRIFY_REMOVAL +typedef struct { + uint32 chip; /* Chip id */ + uint32 chiprev; /* Chip rev */ + uint32 ccrev; /* Chipcommon core rev */ + uint32 siclock; /* Backplane clock */ +} jtagd_id_t; + +/* Jtag configuration structure */ +typedef struct { + uint32 cmd; /* tag to identify the cmd */ + uint8 clkd; /* Jtag clock divisor */ + uint8 disgpio; /* Gpio to disable external driver */ + uint8 irsz; /* IR size for readreg/writereg */ + uint8 drsz; /* DR size for readreg/writereg */ + + uint8 bigend; /* Big endian */ + uint8 mode; /* Current mode */ + uint16 delay; /* Delay between jtagm "simple commands" */ + + uint32 retries; /* Number of retries for jtagm operations */ + uint32 ctrl; /* Jtag control reg copy */ + uint32 ir_lvbase; /* Bits to add to IR values in LV tap */ + uint32 dretries; /* Number of retries for dma operations */ +} jtagconf_t; + +/* struct for jtag scan */ +#define MAX_USB_IR_BITS 256 +#define MAX_USB_DR_BITS 3072 +#define USB_IR_WORDS (MAX_USB_IR_BITS / 32) +#define USB_DR_WORDS (MAX_USB_DR_BITS / 32) +typedef struct { + uint32 cmd; /* tag to identify the cmd */ + uint32 irsz; /* IR size in bits */ + uint32 drsz; /* DR size in bits */ + uint32 ts; /* Terminal state (def, pause, rti) */ + uint32 data[USB_IR_WORDS + USB_DR_WORDS]; /* IR & DR data */ +} scjt_t; +#endif /* LINUX_POSTMOGRIFY_REMOVAL */ + +/* struct for querying nvram params from bootloader */ +#define QUERY_STRING_MAX 32 +typedef struct { + uint32 cmd; /* tag to identify the cmd */ + char var[QUERY_STRING_MAX]; /* param name */ +} nvparam_t; + +typedef void (*exec_fn_t)(void *sih); + +#define USB_CTRL_IN (USB_TYPE_VENDOR | 0x80 | USB_RECIP_INTERFACE) +#define USB_CTRL_OUT (USB_TYPE_VENDOR | 0 | USB_RECIP_INTERFACE) + +#define USB_CTRL_EP_TIMEOUT 500 /* Timeout used in USB control_msg transactions. */ + +#define RDL_CHUNK 1500 /* size of each dl transfer */ + +/* bootloader makes special use of trx header "offsets" array */ +#define TRX_OFFSETS_DLFWLEN_IDX 0 /* Size of the fw; used in uncompressed case */ +#define TRX_OFFSETS_JUMPTO_IDX 1 /* RAM address for jumpto after download */ +#define TRX_OFFSETS_NVM_LEN_IDX 2 /* Length of appended NVRAM data */ + +#define TRX_OFFSETS_DLBASE_IDX 0 /* RAM start address for download */ + +#endif /* _USB_RDL_H */ |