snowball/u-boot-ux500.git - u-boot for ux500

Age	Commit message (Collapse)	Author
2009-10-28	galaxy5200: Add default environment variables	Eric Millbrandt
	Extend bootdelay to 10 seconds. Set boot retry time to 120 seconds and use reset to retry. Define default bootcommand and bootargs for production. Signed-off-by: Eric Millbrandt <emillbrandt@dekaresearch.com>
2009-10-18	galaxy5200: change cs1 configuration	Eric Millbrandt
	Correct the chip select configuration for the nand flash chip select. Signed-off-by: Eric Millbrandt <emillbrandt@dekaresearch.com>
2009-09-24	galaxy5200: enable version environment variable	Eric Millbrandt
	Add version environment variable configuration to the galaxy5200 board header file. Signed-off-by: Eric Millbrandt <emillbrandt@dekaresearch.com> Edited commit message. Signed-off-by: Wolfgang Denk <wd@denx.de>
2009-09-06	Reset i2c slave devices during init on mpc5xxx cpus	Eric Millbrandt
	Reset any i2c devices that may have been interrupted during a system reset. Normally this would be accomplished by clocking the line until SCL and SDA are released and then sending a start condtiion (From an Atmel datasheet). There is no direct access to the i2c pins so instead create start commands through the i2c interface. Send a start command then delay for the SDA Hold time, repeat this by disabling/enabling the bus a total of 9 times. Signed-off-by: Eric Millbrandt <emillbrandt@dekaresearch.com>
2009-09-04	galaxy5200: Add chip select region for an Epson S1D15313	Eric Millbrandt
	Signed-off-by: Eric Millbrandt <emillbrandt@dekaresearch.com>
2009-08-26	galaxy5200: Cleanup typo and trailing whitespace	Eric Millbrandt
	Signed-off-by: Eric Millbrandt <emillbrandt@dekaresearch.com>
2009-08-25	Add support for the galaxy5200	Eric Millbrandt
	Add support for the DEKA Research and Development galaxy5200 board The galaxy5200 is an Freescale mpc5200 based embedded industrial control board. Signed-off-by: Eric Millbrandt <emillbrandt@dekaresearch.com>