From 95c44ec485b46ffb43dbdaa299f1491a500fdadf Mon Sep 17 00:00:00 2001 From: Detlev Zundel Date: Wed, 7 Oct 2009 16:38:05 +0200 Subject: tqm5200: Correct comment and code in post_hotkeys_pressed. This fixes the code and the comment according to the original intent of doing an intensive memory test when PSC6_3 is pulled low on the STK52xx. Notably PORT_CONFIG will be overridden with this correct code now, so beware. The original code only worked by coincidence depending on the PORT_CONFIG setting from the header file. The new code was tested to ensure that the (undocumented) memory test still works on the STK52x. Signed-off-by: Detlev Zundel CC: Martin Krause Minor white-space cleanup. Signed-off-by: Wolfgang Denk --- include/configs/TQM5200.h | 14 ++++++++------ 1 file changed, 8 insertions(+), 6 deletions(-) (limited to 'include/configs/TQM5200.h') diff --git a/include/configs/TQM5200.h b/include/configs/TQM5200.h index a4336a750..2154c7870 100644 --- a/include/configs/TQM5200.h +++ b/include/configs/TQM5200.h @@ -540,6 +540,8 @@ * 101 -> use PSC6 as UART. Pins PSC6_0 to PSC6_3 are used. * Extended POST test is not available. * Use for STK52xx, FO300 and CAM5200 boards. + * WARNING: When the extended POST is enabled, these bits will + * be overridden by this code as GPIOs! * use PCI_DIS: Bit 16 (mask 0x00008000): * 1 -> disable PCI controller (on CAM5200 board). * use USB: Bits 18-19 (mask 0x00003000): @@ -552,7 +554,7 @@ * 000 -> All PSC2 pins are GPIOs. * 100 -> UART (on CAM5200 board). * 001 -> CAN1/2 on PSC2 pins. - * Use for REV100 STK52xx boards + * Use for REV100 STK52xx boards * 01x -> Use AC97 (on FO300 board). * use PSC1: Bits 29-31 (mask: 0x00000007): * 100 -> UART (on all boards). @@ -711,20 +713,20 @@ #define CONFIG_SYS_ATA_BASE_ADDR MPC5XXX_ATA -/* Offset for data I/O */ +/* Offset for data I/O */ #define CONFIG_SYS_ATA_DATA_OFFSET (0x0060) -/* Offset for normal register accesses */ +/* Offset for normal register accesses */ #define CONFIG_SYS_ATA_REG_OFFSET (CONFIG_SYS_ATA_DATA_OFFSET) -/* Offset for alternate registers */ +/* Offset for alternate registers */ #define CONFIG_SYS_ATA_ALT_OFFSET (0x005C) -/* Interval between registers */ +/* Interval between registers */ #define CONFIG_SYS_ATA_STRIDE 4 /* Support ATAPI devices */ -#define CONFIG_ATAPI 1 +#define CONFIG_ATAPI 1 /*----------------------------------------------------------------------- * Open firmware flat tree support -- cgit v1.2.3