Merge tag 'spi-v5.12' of git://git.kernel.org/pub/scm/linux/kernel/git/broonie/spi

Pull spi updates from Mark Brown:
 "The main focus of this release from a framework point of view has been
  spi-mem where we've acquired support for a few new hardware features
  which enable better performance on suitable hardware.

  Otherwise mostly thanks to Arnd's cleanup efforts on old platforms
  we've removed several obsolete drivers which just about balance out
  the newer drivers we've added this cycle.

  Summary:

   - Allow drivers to flag if they are unidirectional.

   - Support for DTR mode and hardware acceleration of dummy cycles in
     spi-mem.

   - Support for Allwinder H616, Intel Lightning Mountain, nVidia Tegra
     QuadSPI, Realtek RTL838x and RTL839x.

   - Removal of obsolete EFM32, Txx9 and SIRF Prima and Atlas drivers"

* tag 'spi-v5.12' of git://git.kernel.org/pub/scm/linux/kernel/git/broonie/spi: (76 commits)
  spi: Skip zero-length transfers in spi_transfer_one_message()
  spi: dw: Avoid stack content exposure
  spi: cadence-quadspi: Use spi_mem_dtr_supports_op()
  spi: spi-mem: add spi_mem_dtr_supports_op()
  spi: atmel-quadspi: Disable the QSPI IP at suspend()
  spi: pxa2xx: Add IDs for the controllers found on Intel Lynxpoint
  spi: pxa2xx: Fix the controller numbering for Wildcat Point
  spi: Change provied to provided in the file spi.h
  spi: mediatek: add set_cs_timing support
  spi: support CS timing for HW & SW mode
  spi: add power control when set_cs_timing
  spi: stm32: make spurious and overrun interrupts visible
  spi: stm32h7: replace private SPI_1HZ_NS with NSEC_PER_SEC
  spi: stm32: defer probe for reset
  spi: stm32: driver uses reset controller only at init
  spi: stm32h7: ensure message are smaller than max size
  spi: stm32: use bitfield macros
  spi: stm32: do not mandate cs_gpio
  spi: stm32: properly handle 0 byte transfer
  spi: clps711xx: remove redundant white-space
  ...

2 files changed, 31 insertions, 22 deletions

diff --git a/include/linux/spi/spi-mem.h b/include/linux/spi/spi-mem.h
index 159463cc659c..2b65c9edc34e 100644
--- a/include/linux/spi/spi-mem.h
+++ b/include/linux/spi/spi-mem.h
@@ -311,6 +311,9 @@ void spi_controller_dma_unmap_mem_op_data(struct spi_controller *ctlr,
 bool spi_mem_default_supports_op(struct spi_mem *mem,
 				 const struct spi_mem_op *op);
 
+bool spi_mem_dtr_supports_op(struct spi_mem *mem,
+			     const struct spi_mem_op *op);
+
 #else
 static inline int
 spi_controller_dma_map_mem_op_data(struct spi_controller *ctlr,
@@ -334,6 +337,12 @@ bool spi_mem_default_supports_op(struct spi_mem *mem,
 	return false;
 }
 
+static inline
+bool spi_mem_dtr_supports_op(struct spi_mem *mem,
+			     const struct spi_mem_op *op)
+{
+	return false;
+}
 #endif /* CONFIG_SPI_MEM */
 
 int spi_mem_adjust_op_size(struct spi_mem *mem, struct spi_mem_op *op);
diff --git a/include/linux/spi/spi.h b/include/linux/spi/spi.h
index aa09fdc8042d..592897fa4f03 100644
--- a/include/linux/spi/spi.h
+++ b/include/linux/spi/spi.h
@@ -6,6 +6,7 @@
 #ifndef __LINUX_SPI_H
 #define __LINUX_SPI_H
 
+#include <linux/bits.h>
 #include <linux/device.h>
 #include <linux/mod_devicetable.h>
 #include <linux/slab.h>
@@ -15,6 +16,8 @@
 #include <linux/gpio/consumer.h>
 #include <linux/ptp_clock_kernel.h>
 
+#include <uapi/linux/spi/spi.h>
+
 struct dma_chan;
 struct property_entry;
 struct spi_controller;
@@ -164,28 +167,19 @@ struct spi_device {
 	u8			chip_select;
 	u8			bits_per_word;
 	bool			rt;
+#define SPI_NO_TX	BIT(31)		/* no transmit wire */
+#define SPI_NO_RX	BIT(30)		/* no receive wire */
+	/*
+	 * All bits defined above should be covered by SPI_MODE_KERNEL_MASK.
+	 * The SPI_MODE_KERNEL_MASK has the SPI_MODE_USER_MASK counterpart,
+	 * which is defined in 'include/uapi/linux/spi/spi.h'.
+	 * The bits defined here are from bit 31 downwards, while in
+	 * SPI_MODE_USER_MASK are from 0 upwards.
+	 * These bits must not overlap. A static assert check should make sure of that.
+	 * If adding extra bits, make sure to decrease the bit index below as well.
+	 */
+#define SPI_MODE_KERNEL_MASK	(~(BIT(30) - 1))
 	u32			mode;
-#define	SPI_CPHA	0x01			/* clock phase */
-#define	SPI_CPOL	0x02			/* clock polarity */
-#define	SPI_MODE_0	(0|0)			/* (original MicroWire) */
-#define	SPI_MODE_1	(0|SPI_CPHA)
-#define	SPI_MODE_2	(SPI_CPOL|0)
-#define	SPI_MODE_3	(SPI_CPOL|SPI_CPHA)
-#define	SPI_MODE_X_MASK	(SPI_CPOL|SPI_CPHA)
-#define	SPI_CS_HIGH	0x04			/* chipselect active high? */
-#define	SPI_LSB_FIRST	0x08			/* per-word bits-on-wire */
-#define	SPI_3WIRE	0x10			/* SI/SO signals shared */
-#define	SPI_LOOP	0x20			/* loopback mode */
-#define	SPI_NO_CS	0x40			/* 1 dev/bus, no chipselect */
-#define	SPI_READY	0x80			/* slave pulls low to pause */
-#define	SPI_TX_DUAL	0x100			/* transmit with 2 wires */
-#define	SPI_TX_QUAD	0x200			/* transmit with 4 wires */
-#define	SPI_RX_DUAL	0x400			/* receive with 2 wires */
-#define	SPI_RX_QUAD	0x800			/* receive with 4 wires */
-#define	SPI_CS_WORD	0x1000			/* toggle cs after each word */
-#define	SPI_TX_OCTAL	0x2000			/* transmit with 8 wires */
-#define	SPI_RX_OCTAL	0x4000			/* receive with 8 wires */
-#define	SPI_3WIRE_HIZ	0x8000			/* high impedance turnaround */
 	int			irq;
 	void			*controller_state;
 	void			*controller_data;
@@ -208,6 +202,10 @@ struct spi_device {
 	 */
 };
 
+/* Make sure that SPI_MODE_KERNEL_MASK & SPI_MODE_USER_MASK don't overlap */
+static_assert((SPI_MODE_KERNEL_MASK & SPI_MODE_USER_MASK) == 0,
+	      "SPI_MODE_USER_MASK & SPI_MODE_KERNEL_MASK must not overlap");
+
 static inline struct spi_device *to_spi_device(struct device *dev)
 {
 	return dev ? container_of(dev, struct spi_device, dev) : NULL;
@@ -624,7 +622,7 @@ struct spi_controller {
 
 	/*
 	 * These hooks are for drivers that use a generic implementation
-	 * of transfer_one_message() provied by the core.
+	 * of transfer_one_message() provided by the core.
 	 */
 	void (*set_cs)(struct spi_device *spi, bool enable);
 	int (*transfer_one)(struct spi_controller *ctlr, struct spi_device *spi,
@@ -827,6 +825,7 @@ extern void spi_res_release(struct spi_controller *ctlr,
  *      transfer. If 0 the default (from @spi_device) is used.
  * @bits_per_word: select a bits_per_word other than the device default
  *      for this transfer. If 0 the default (from @spi_device) is used.
+ * @dummy_data: indicates transfer is dummy bytes transfer.
  * @cs_change: affects chipselect after this transfer completes
  * @cs_change_delay: delay between cs deassert and assert when
  *      @cs_change is set and @spi_transfer is not the last in @spi_message
@@ -939,6 +938,7 @@ struct spi_transfer {
 	struct sg_table tx_sg;
 	struct sg_table rx_sg;
 
+	unsigned	dummy_data:1;
 	unsigned	cs_change:1;
 	unsigned	tx_nbits:3;
 	unsigned	rx_nbits:3;