diff options
Diffstat (limited to 'Documentation/devicetree/bindings/mmc/synopsys-dw-mshc.txt')
| -rw-r--r-- | Documentation/devicetree/bindings/mmc/synopsys-dw-mshc.txt | 13 |
1 files changed, 7 insertions, 6 deletions
diff --git a/Documentation/devicetree/bindings/mmc/synopsys-dw-mshc.txt b/Documentation/devicetree/bindings/mmc/synopsys-dw-mshc.txt index 4e00e859e885..7fd17c3da116 100644 --- a/Documentation/devicetree/bindings/mmc/synopsys-dw-mshc.txt +++ b/Documentation/devicetree/bindings/mmc/synopsys-dw-mshc.txt @@ -43,6 +43,9 @@ Optional properties: reset signal present internally in some host controller IC designs. See Documentation/devicetree/bindings/reset/reset.txt for details. +* reset-names: request name for using "resets" property. Must be "reset". + (It will be used together with "resets" property.) + * clocks: from common clock binding: handle to biu and ciu clocks for the bus interface unit clock and the card interface unit clock. @@ -56,8 +59,9 @@ Optional properties: is specified and the ciu clock is specified then we'll try to set the ciu clock to this at probe time. -* clock-freq-min-max: Minimum and Maximum clock frequency for card output +* clock-freq-min-max (DEPRECATED): Minimum and Maximum clock frequency for card output clock(cclk_out). If it's not specified, max is 200MHZ and min is 400KHz by default. + (Use the "max-frequency" instead of "clock-freq-min-max".) * num-slots: specifies the number of slots supported by the controller. The number of physical slots actually used could be equal or less than the @@ -71,11 +75,6 @@ Optional properties: * card-detect-delay: Delay in milli-seconds before detecting card after card insert event. The default value is 0. -* supports-highspeed (DEPRECATED): Enables support for high speed cards (up to 50MHz) - (use "cap-mmc-highspeed" or "cap-sd-highspeed" instead) - -* broken-cd: as documented in mmc core bindings. - * vmmc-supply: The phandle to the regulator to use for vmmc. If this is specified we'll defer probe until we can find this regulator. @@ -103,6 +102,8 @@ board specific portions as listed below. interrupts = <0 75 0>; #address-cells = <1>; #size-cells = <0>; + resets = <&rst 20>; + reset-names = "reset"; }; [board specific internal DMA resources] |