diff options
Diffstat (limited to 'Documentation/kernel-parameters.txt')
| -rw-r--r-- | Documentation/kernel-parameters.txt | 24 |
1 files changed, 14 insertions, 10 deletions
diff --git a/Documentation/kernel-parameters.txt b/Documentation/kernel-parameters.txt index 01085cdc47c1..fcf05a07b06a 100644 --- a/Documentation/kernel-parameters.txt +++ b/Documentation/kernel-parameters.txt @@ -1698,7 +1698,7 @@ bytes respectively. Such letter suffixes can also be entirely omitted. intel_idle.max_cstate= [KNL,HW,ACPI,X86] 0 disables intel_idle and fall back on acpi_idle. - 1 to 6 specify maximum depth of C-state. + 1 to 9 specify maximum depth of C-state. intel_pstate= [X86] disable @@ -2171,10 +2171,13 @@ bytes respectively. Such letter suffixes can also be entirely omitted. than or equal to this physical address is ignored. maxcpus= [SMP] Maximum number of processors that an SMP kernel - should make use of. maxcpus=n : n >= 0 limits the - kernel to using 'n' processors. n=0 is a special case, - it is equivalent to "nosmp", which also disables - the IO APIC. + will bring up during bootup. maxcpus=n : n >= 0 limits + the kernel to bring up 'n' processors. Surely after + bootup you can bring up the other plugged cpu by executing + "echo 1 > /sys/devices/system/cpu/cpuX/online". So maxcpus + only takes effect during system bootup. + While n=0 is a special case, it is equivalent to "nosmp", + which also disables the IO APIC. max_loop= [LOOP] The number of loop block devices that get (loop.max_loop) unconditionally pre-created at init time. The default @@ -2581,8 +2584,6 @@ bytes respectively. Such letter suffixes can also be entirely omitted. nodelayacct [KNL] Disable per-task delay accounting - nodisconnect [HW,SCSI,M68K] Disables SCSI disconnects. - nodsp [SH] Disable hardware DSP at boot time. noefi Disable EFI runtime services support. @@ -2783,9 +2784,12 @@ bytes respectively. Such letter suffixes can also be entirely omitted. nr_cpus= [SMP] Maximum number of processors that an SMP kernel could support. nr_cpus=n : n >= 1 limits the kernel to - supporting 'n' processors. Later in runtime you can not - use hotplug cpu feature to put more cpu back to online. - just like you compile the kernel NR_CPUS=n + support 'n' processors. It could be larger than the + number of already plugged CPU during bootup, later in + runtime you can physically add extra cpu until it reaches + n. So during boot up some boot time memory for per-cpu + variables need be pre-allocated for later physical cpu + hot plugging. nr_uarts= [SERIAL] maximum number of UARTs to be registered. |