diff options
Diffstat (limited to 'drivers/net')
-rw-r--r-- | drivers/net/bnx2x_link.c | 2 | ||||
-rw-r--r-- | drivers/net/e1000/e1000_hw.c | 4 | ||||
-rw-r--r-- | drivers/net/slip.h | 2 | ||||
-rw-r--r-- | drivers/net/tehuti.c | 4 | ||||
-rw-r--r-- | drivers/net/tokenring/smctr.c | 2 | ||||
-rw-r--r-- | drivers/net/wireless/atmel.c | 2 | ||||
-rw-r--r-- | drivers/net/wireless/ipw2x00/ipw2100.c | 4 | ||||
-rw-r--r-- | drivers/net/wireless/rt2x00/rt2x00crypto.c | 4 | ||||
-rw-r--r-- | drivers/net/wireless/strip.c | 2 |
9 files changed, 13 insertions, 13 deletions
diff --git a/drivers/net/bnx2x_link.c b/drivers/net/bnx2x_link.c index 67de94f1f30e..fefa6ab13064 100644 --- a/drivers/net/bnx2x_link.c +++ b/drivers/net/bnx2x_link.c @@ -3359,7 +3359,7 @@ static u8 bnx2x_format_ver(u32 num, u8 *str, u16 len) u8 shift = 8*4; u8 digit; if (len < 10) { - /* Need more then 10chars for this format */ + /* Need more than 10chars for this format */ *str_ptr = '\0'; return -EINVAL; } diff --git a/drivers/net/e1000/e1000_hw.c b/drivers/net/e1000/e1000_hw.c index d04eef53571e..e1a3fc1303ee 100644 --- a/drivers/net/e1000/e1000_hw.c +++ b/drivers/net/e1000/e1000_hw.c @@ -6758,7 +6758,7 @@ static s32 e1000_get_cable_length(struct e1000_hw *hw, u16 *min_length, * returns: - E1000_ERR_XXX * E1000_SUCCESS * - * For phy's older then IGP, this function simply reads the polarity bit in the + * For phy's older than IGP, this function simply reads the polarity bit in the * Phy Status register. For IGP phy's, this bit is valid only if link speed is * 10 Mbps. If the link speed is 100 Mbps there is no polarity so this bit will * return 0. If the link speed is 1000 Mbps the polarity status is in the @@ -6834,7 +6834,7 @@ static s32 e1000_check_polarity(struct e1000_hw *hw, * returns: - E1000_ERR_XXX * E1000_SUCCESS * - * For phy's older then IGP, this function reads the Downshift bit in the Phy + * For phy's older than IGP, this function reads the Downshift bit in the Phy * Specific Status register. For IGP phy's, it reads the Downgrade bit in the * Link Health register. In IGP this bit is latched high, so the driver must * read it immediately after link is established. diff --git a/drivers/net/slip.h b/drivers/net/slip.h index 853e0f6ec710..9ea5c11287d2 100644 --- a/drivers/net/slip.h +++ b/drivers/net/slip.h @@ -75,7 +75,7 @@ struct slip { unsigned long tx_errors; /* Planned stuff */ unsigned long rx_dropped; /* No memory for skb */ unsigned long tx_dropped; /* When MTU change */ - unsigned long rx_over_errors; /* Frame bigger then SLIP buf. */ + unsigned long rx_over_errors; /* Frame bigger than SLIP buf. */ #ifdef SL_INCLUDE_CSLIP unsigned long tx_compressed; unsigned long rx_compressed; diff --git a/drivers/net/tehuti.c b/drivers/net/tehuti.c index a10a83a11d9f..a7a4dc4d6313 100644 --- a/drivers/net/tehuti.c +++ b/drivers/net/tehuti.c @@ -1004,7 +1004,7 @@ static inline void bdx_rxdb_free_elem(struct rxdb *db, int n) * skb for rx. It assumes that Rx is desabled in HW * funcs are grouped for better cache usage * - * RxD fifo is smaller then RxF fifo by design. Upon high load, RxD will be + * RxD fifo is smaller than RxF fifo by design. Upon high load, RxD will be * filled and packets will be dropped by nic without getting into host or * cousing interrupt. Anyway, in that condition, host has no chance to proccess * all packets, but dropping in nic is cheaper, since it takes 0 cpu cycles @@ -1826,7 +1826,7 @@ static void bdx_tx_free(struct bdx_priv *priv) * * Pushes desc to TxD fifo and overlaps it if needed. * NOTE: this func does not check for available space. this is responsibility - * of the caller. Neither does it check that data size is smaller then + * of the caller. Neither does it check that data size is smaller than * fifo size. */ static void bdx_tx_push_desc(struct bdx_priv *priv, void *data, int size) diff --git a/drivers/net/tokenring/smctr.c b/drivers/net/tokenring/smctr.c index a011666342ff..50eb29ce3c87 100644 --- a/drivers/net/tokenring/smctr.c +++ b/drivers/net/tokenring/smctr.c @@ -3064,7 +3064,7 @@ static int smctr_load_node_addr(struct net_device *dev) * will consequently cause a timeout. * * NOTE 1: If the monitor_state is MS_BEACON_TEST_STATE, all transmit - * queues other then the one used for the lobe_media_test should be + * queues other than the one used for the lobe_media_test should be * disabled.!? * * NOTE 2: If the monitor_state is MS_BEACON_TEST_STATE and the receive_mask diff --git a/drivers/net/wireless/atmel.c b/drivers/net/wireless/atmel.c index 350157fcd080..4223672c4432 100644 --- a/drivers/net/wireless/atmel.c +++ b/drivers/net/wireless/atmel.c @@ -3836,7 +3836,7 @@ static int reset_atmel_card(struct net_device *dev) This routine is also responsible for initialising some hardware-specific fields in the atmel_private structure, including a copy of the firmware's hostinfo stucture - which is the route into the rest of the firmare datastructures. */ + which is the route into the rest of the firmware datastructures. */ struct atmel_private *priv = netdev_priv(dev); u8 configuration; diff --git a/drivers/net/wireless/ipw2x00/ipw2100.c b/drivers/net/wireless/ipw2x00/ipw2100.c index 1667065b86a7..823c2bf5e31e 100644 --- a/drivers/net/wireless/ipw2x00/ipw2100.c +++ b/drivers/net/wireless/ipw2x00/ipw2100.c @@ -1332,7 +1332,7 @@ static int ipw2100_power_cycle_adapter(struct ipw2100_priv *priv) IPW_AUX_HOST_RESET_REG_STOP_MASTER); /* Step 2. Wait for stop Master Assert - * (not more then 50us, otherwise ret error */ + * (not more than 50us, otherwise ret error */ i = 5; do { udelay(IPW_WAIT_RESET_MASTER_ASSERT_COMPLETE_DELAY); @@ -1830,7 +1830,7 @@ static void ipw2100_down(struct ipw2100_priv *priv) cancel_delayed_work(&priv->rf_kill); } - /* Kill the firmare hang check timer */ + /* Kill the firmware hang check timer */ if (!priv->stop_hang_check) { priv->stop_hang_check = 1; cancel_delayed_work(&priv->hang_check); diff --git a/drivers/net/wireless/rt2x00/rt2x00crypto.c b/drivers/net/wireless/rt2x00/rt2x00crypto.c index 37ad0d2fb64c..aee9cba13eb3 100644 --- a/drivers/net/wireless/rt2x00/rt2x00crypto.c +++ b/drivers/net/wireless/rt2x00/rt2x00crypto.c @@ -184,8 +184,8 @@ void rt2x00crypto_rx_insert_iv(struct sk_buff *skb, unsigned int align, * Make room for new data, note that we increase both * headsize and tailsize when required. The tailsize is * only needed when ICV data needs to be inserted and - * the padding is smaller then the ICV data. - * When alignment requirements is greater then the + * the padding is smaller than the ICV data. + * When alignment requirements is greater than the * ICV data we must trim the skb to the correct size * because we need to remove the extra bytes. */ diff --git a/drivers/net/wireless/strip.c b/drivers/net/wireless/strip.c index dd0de3a9ed4e..7015f2480550 100644 --- a/drivers/net/wireless/strip.c +++ b/drivers/net/wireless/strip.c @@ -236,7 +236,7 @@ struct strip { unsigned long tx_errors; /* Planned stuff */ unsigned long rx_dropped; /* No memory for skb */ unsigned long tx_dropped; /* When MTU change */ - unsigned long rx_over_errors; /* Frame bigger then STRIP buf. */ + unsigned long rx_over_errors; /* Frame bigger than STRIP buf. */ unsigned long pps_timer; /* Timer to determine pps */ unsigned long rx_pps_count; /* Counter to determine pps */ |