From 71b149b3f740501c2d59c80de5b10f5e45051099 Mon Sep 17 00:00:00 2001 From: Jean-Christophe PLAGNIOL-VILLARD Date: Thu, 5 Apr 2012 14:14:28 +0800 Subject: ARM: at91: do not pin mux the UARTs in init_early There is no need to pinmux the UART so early in the kernel. Move it to the board init. This will also allow to finally move the gpio driver to platform device/driver. Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD Acked-by: Nicolas Ferre --- arch/arm/mach-at91/board-neocore926.c | 11 +++++------ 1 file changed, 5 insertions(+), 6 deletions(-) (limited to 'arch/arm/mach-at91/board-neocore926.c') diff --git a/arch/arm/mach-at91/board-neocore926.c b/arch/arm/mach-at91/board-neocore926.c index c456fdc7cf21..d2f4cc161766 100644 --- a/arch/arm/mach-at91/board-neocore926.c +++ b/arch/arm/mach-at91/board-neocore926.c @@ -55,12 +55,6 @@ static void __init neocore926_init_early(void) { /* Initialize processor: 20 MHz crystal */ at91_initialize(20000000); - - /* DBGU on ttyS0. (Rx & Tx only) */ - at91_register_uart(0, 0, 0); - - /* USART0 on ttyS1. (Rx, Tx, RTS, CTS) */ - at91_register_uart(AT91SAM9263_ID_US0, 1, ATMEL_UART_CTS | ATMEL_UART_RTS); } /* @@ -338,6 +332,11 @@ static struct ac97c_platform_data neocore926_ac97_data = { static void __init neocore926_board_init(void) { /* Serial */ + /* DBGU on ttyS0. (Rx & Tx only) */ + at91_register_uart(0, 0, 0); + + /* USART0 on ttyS1. (Rx, Tx, RTS, CTS) */ + at91_register_uart(AT91SAM9263_ID_US0, 1, ATMEL_UART_CTS | ATMEL_UART_RTS); at91_add_device_serial(); /* USB Host */ -- cgit v1.2.3