blob: 1fd9a4406a1dbc0363644b4a5122462461e1ebc9 (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
|
Nuvoton NPCM Peripheral Serial Peripheral Interface(PSPI) controller driver
Nuvoton NPCM7xx SOC support two PSPI channels.
Required properties:
- compatible : "nuvoton,npcm750-pspi" for NPCM7XX BMC
- #address-cells : should be 1. see spi-bus.txt
- #size-cells : should be 0. see spi-bus.txt
- specifies physical base address and size of the register.
- interrupts : contain PSPI interrupt.
- clocks : phandle of PSPI reference clock.
- clock-names: Should be "clk_apb5".
- pinctrl-names : a pinctrl state named "default" must be defined.
- pinctrl-0 : phandle referencing pin configuration of the device.
- cs-gpios: Specifies the gpio pins to be used for chipselects.
See: Documentation/devicetree/bindings/spi/spi-bus.txt
Optional properties:
- clock-frequency : Input clock frequency to the PSPI block in Hz.
Default is 25000000 Hz.
Aliases:
- All the SPI controller nodes should be represented in the aliases node using
the following format 'spi{n}' withe the correct numbered in "aliases" node.
Example:
aliases {
spi0 = &spi0;
};
spi0: spi@f0200000 {
compatible = "nuvoton,npcm750-pspi";
reg = <0xf0200000 0x1000>;
pinctrl-names = "default";
pinctrl-0 = <&pspi1_pins>;
#address-cells = <1>;
#size-cells = <0>;
interrupts = <GIC_SPI 31 IRQ_TYPE_LEVEL_HIGH>;
clocks = <&clk NPCM7XX_CLK_APB5>;
clock-names = "clk_apb5";
cs-gpios = <&gpio6 11 GPIO_ACTIVE_LOW>;
};
|
