diff options
Diffstat (limited to 'drivers/fc4/Kconfig')
| -rw-r--r-- | drivers/fc4/Kconfig | 81 |
1 files changed, 0 insertions, 81 deletions
diff --git a/drivers/fc4/Kconfig b/drivers/fc4/Kconfig deleted file mode 100644 index 345dbe6f10d..00000000000 --- a/drivers/fc4/Kconfig +++ /dev/null @@ -1,81 +0,0 @@ -# -# FC4 device configuration -# - -menu "Fibre Channel support" - -config FC4 - tristate "Fibre Channel and FC4 SCSI support" - ---help--- - Fibre Channel is a high speed serial protocol mainly used to - connect large storage devices to the computer; it is compatible with - and intended to replace SCSI. - - This is an experimental support for storage arrays connected to your - computer using optical fibre cables and the "X3.269-199X Fibre - Channel Protocol for SCSI" specification. If you want to use this, - you need to say Y here and to "SCSI support" as well as to the - drivers for the storage array itself and for the interface adapter - such as SOC or SOC+. This subsystem could even serve for IP - networking, with some code extensions. - - If unsure, say N. - -comment "FC4 drivers" - depends on FC4 - -config FC4_SOC - tristate "Sun SOC/Sbus" - depends on FC4!=n && SPARC - help - Serial Optical Channel is an interface card with one or two Fibre - Optic ports, each of which can be connected to a disk array. Note - that if you have older firmware in the card, you'll need the - microcode from the Solaris driver to make it work. - - To compile this support as a module, choose M here: the module will - be called soc. - -config FC4_SOCAL - tristate "Sun SOC+ (aka SOCAL)" - depends on FC4!=n && SPARC - ---help--- - Serial Optical Channel Plus is an interface card with up to two - Fibre Optic ports. This card supports FC Arbitrated Loop (usually - A5000 or internal FC disks in E[3-6]000 machines through the - Interface Board). You'll probably need the microcode from the - Solaris driver to make it work. - - To compile this support as a module, choose M here: the module will - be called socal. - -comment "FC4 targets" - depends on FC4 - -config SCSI_PLUTO - tristate "SparcSTORAGE Array 100 and 200 series" - depends on FC4!=n && SCSI - help - If you never bought a disk array made by Sun, go with N. - - To compile this support as a module, choose M here: the module will - be called pluto. - -config SCSI_FCAL - tristate "Sun Enterprise Network Array (A5000 and EX500)" if SPARC - depends on FC4!=n && SCSI - help - This driver drives FC-AL disks connected through a Fibre Channel - card using the drivers/fc4 layer (currently only SOCAL). The most - common is either A5000 array or internal disks in E[3-6]000 - machines. - - To compile this support as a module, choose M here: the module will - be called fcal. - -config SCSI_FCAL - prompt "Generic FC-AL disk driver" - depends on FC4!=n && SCSI && !SPARC - -endmenu - |