From dd14be4c274fc484eccace03ae9726e516630331 Mon Sep 17 00:00:00 2001 From: Richard Röjfors Date: Fri, 5 Jun 2009 15:40:32 +0200 Subject: i2c-ocores: Can add I2C devices to the bus MIME-Version: 1.0 Content-Type: text/plain; charset=UTF-8 Content-Transfer-Encoding: 8bit There is sometimes a need for the ocores driver to add devices to the bus when installed. i2c_register_board_info can not always be used, because the I2C devices are not known at an early state, they could for instance be connected on a I2C bus on a PCI device which has the Open Cores IP. i2c_new_device can not be used in all cases either since the resulting bus nummer might be unknown. The solution is the pass a list of I2C devices in the platform data to the Open Cores driver. This is useful for MFD drivers. Signed-off-by: Richard Röjfors Signed-off-by: Ben Dooks --- Documentation/i2c/busses/i2c-ocores | 17 +++++++++++++++++ 1 file changed, 17 insertions(+) (limited to 'Documentation') diff --git a/Documentation/i2c/busses/i2c-ocores b/Documentation/i2c/busses/i2c-ocores index cfcebb10d14..c269aaa2f26 100644 --- a/Documentation/i2c/busses/i2c-ocores +++ b/Documentation/i2c/busses/i2c-ocores @@ -20,6 +20,8 @@ platform_device with the base address and interrupt number. The dev.platform_data of the device should also point to a struct ocores_i2c_platform_data (see linux/i2c-ocores.h) describing the distance between registers and the input clock speed. +There is also a possibility to attach a list of i2c_board_info which +the i2c-ocores driver will add to the bus upon creation. E.G. something like: @@ -36,9 +38,24 @@ static struct resource ocores_resources[] = { }, }; +/* optional board info */ +struct i2c_board_info ocores_i2c_board_info[] = { + { + I2C_BOARD_INFO("tsc2003", 0x48), + .platform_data = &tsc2003_platform_data, + .irq = TSC_IRQ + }, + { + I2C_BOARD_INFO("adv7180", 0x42 >> 1), + .irq = ADV_IRQ + } +}; + static struct ocores_i2c_platform_data myi2c_data = { .regstep = 2, /* two bytes between registers */ .clock_khz = 50000, /* input clock of 50MHz */ + .devices = ocores_i2c_board_info, /* optional table of devices */ + .num_devices = ARRAY_SIZE(ocores_i2c_board_info), /* table size */ }; static struct platform_device myi2c = { -- cgit v1.2.3