From cf85d08fdf4548ee46657ccfb7f9949a85145db5 Mon Sep 17 00:00:00 2001 From: Lennert Buytenhek Date: Tue, 7 Oct 2008 13:45:02 +0000 Subject: dsa: add support for original DSA tagging format Most of the DSA switches currently in the field do not support the Ethertype DSA tagging format that one of the previous patches added support for, but only the original DSA tagging format. The original DSA tagging format carries the same information as the Ethertype DSA tagging format, but with the difference that it does not have an ethertype field. In other words, when receiving a packet that is tagged with an original DSA tag, there is no way of telling in eth_type_trans() that this packet is in fact a DSA-tagged packet. This patch adds a hook into eth_type_trans() which is only compiled in if support for a switch chip that doesn't support Ethertype DSA is selected, and which checks whether there is a DSA switch driver instance attached to this network device which uses the old tag format. If so, it sets the protocol field to ETH_P_DSA without looking at the packet, so that the packet ends up in the right place. Signed-off-by: Lennert Buytenhek Tested-by: Nicolas Pitre Tested-by: Peter van Valderen Tested-by: Dirk Teurlings Signed-off-by: David S. Miller --- net/dsa/mv88e6123_61_65.c | 18 +++++++++++------- 1 file changed, 11 insertions(+), 7 deletions(-) (limited to 'net/dsa/mv88e6123_61_65.c') diff --git a/net/dsa/mv88e6123_61_65.c b/net/dsa/mv88e6123_61_65.c index 147818cc706..555b164082f 100644 --- a/net/dsa/mv88e6123_61_65.c +++ b/net/dsa/mv88e6123_61_65.c @@ -192,15 +192,19 @@ static int mv88e6123_61_65_setup_port(struct dsa_switch *ds, int p) /* * Port Control: disable Drop-on-Unlock, disable Drop-on-Lock, - * configure the EDSA tagging mode if this is the CPU port, - * disable Header mode, enable IGMP/MLD snooping, disable VLAN - * tunneling, determine priority by looking at 802.1p and IP - * priority fields (IP prio has precedence), and set STP state - * to Forwarding. Finally, if this is the CPU port, additionally - * enable forwarding of unknown unicast and multicast addresses. + * configure the requested (DSA/EDSA) tagging mode if this is + * the CPU port, disable Header mode, enable IGMP/MLD snooping, + * disable VLAN tunneling, determine priority by looking at + * 802.1p and IP priority fields (IP prio has precedence), and + * set STP state to Forwarding. Finally, if this is the CPU + * port, additionally enable forwarding of unknown unicast and + * multicast addresses. */ REG_WRITE(addr, 0x04, - (p == ds->cpu_port) ? 0x373f : 0x0433); + (p == ds->cpu_port) ? + (ds->tag_protocol == htons(ETH_P_DSA)) ? + 0x053f : 0x373f : + 0x0433); /* * Port Control 1: disable trunking. Also, if this is the -- cgit v1.2.3