1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
|
#
# M6718 modem SPI IPC driver kernel configuration
#
config MODEM_M6718_SPI
tristate "M6718 modem IPC SPI driver"
depends on MODEM_M6718
default y
---help---
If you say Y here, you will enable the M6718 modem IPC SPI driver.
If unsure, say Y.
config MODEM_M6718_SPI_DEBUG
boolean "Modem driver debug"
depends on MODEM_M6718_SPI
default N
---help---
If you say Y here, you will enable full debug trace from the M6718
modem driver. This should not be enabled by default.
If unsure, say N.
config MODEM_M6718_SPI_ENABLE_FEATURE_MODEM_STATE
boolean "M6718 modem state driver integration"
depends on MODEM_M6718_SPI
default y
---help---
Enables integration of the IPC driver with the modem state driver.
This allows the IPC driver to be notified of changes in modem state
(on, off, reset) and allows the IPC driver to cause modem state
changes if needed.
By default this should be enabled.
config MODEM_M6718_SPI_ENABLE_FEATURE_FRAME_DUMP
boolean "IPC SPI L1 frame dump"
depends on MODEM_M6718_SPI
default n
---help---
If you say Y here, you will enable dumping of the raw TX and RX frames
by the IPC driver L1.
If unsure, say N.
config MODEM_M6718_SPI_ENABLE_FEATURE_LOOPBACK
boolean "Modem IPC loopback support"
depends on MODEM_M6718_SPI
default y
---help---
If you say Y here, you will enable the IPC loopback channels/devices.
If unsure, say Y.
config MODEM_M6718_SPI_ENABLE_FEATURE_VERIFY_FRAMES
boolean "Verify loopback frames"
depends on MODEM_M6718_SPI
default n
---help---
This will enabling checking of loopback frames to verify that the data
received is identical to the data sent.
If unsure, say N.
config MODEM_M6718_SPI_ENABLE_FEATURE_THROUGHPUT_MEASUREMENT
boolean "Modem IPC throughput measurement"
depends on MODEM_M6718_SPI
default n
---help---
If you say Y here, you will enable the IPC link throughput
measurement and reporting.
If unsure, say N.
config MODEM_M6718_SPI_SET_THROUGHPUT_FREQUENCY
int "Sample rate for throughput measurements (seconds)"
default "5"
depends on MODEM_M6718_SPI_ENABLE_FEATURE_THROUGHPUT_MEASUREMENT
help
The sample frequency for taking IPC SPI link throughput measurements.
Increasing the rate (reducing the time) will increase the accuracy of
the measurements, but will also increase the impact on link and system
performance.
|