From d6815435c0e8619de0d1e1a66a805d0762b5af89 Mon Sep 17 00:00:00 2001 From: wdenk Date: Mon, 12 May 2003 09:51:00 +0000 Subject: Add default switch settings. --- doc/README.Purple | 29 ++++++++++++++++++++++++++--- 1 file changed, 26 insertions(+), 3 deletions(-) (limited to 'doc/README.Purple') diff --git a/doc/README.Purple b/doc/README.Purple index 9e70004ae..c05e0ff36 100644 --- a/doc/README.Purple +++ b/doc/README.Purple @@ -11,6 +11,20 @@ Installation Instructions: | X| ------ + Put the s3 switch into the following position: + + 1 0 + ------ + |x | + |x | + |x | + |x | + |x | + | x| + | x| + |x | + ------ + 2. Connect to the serial console and to the BDI. Power on. On the serial line, you should see: @@ -34,8 +48,17 @@ Installation Instructions: prog 0xB0000000 bin -6. Power off. Restore the original S2 switch position. Power on. - U-Boot should come up. +6. Power off. Restore the original S2 switch position: + + 1 0 + ------ + | x| + | x| + |x | + | X| + ------ + + Power on. U-Boot should come up. @@ -48,5 +71,5 @@ can't really check whether 'erase' is complete by polling flash as it is usually done. Instead, the flash driver simply waits for a given time and assumes that erase then has passed. This behaviour is identical to what the VxWorks driver does; also, the same timeout (6 -seconds) was chosen. Note that this timeout applies for each errase +seconds) was chosen. Note that this timeout applies for each erase operation, i. e. per erased sector. -- cgit v1.2.3