diff options
Diffstat (limited to 'board')
-rw-r--r-- | board/olimex/imx233_olinuxino/readme.txt | 70 |
1 files changed, 0 insertions, 70 deletions
diff --git a/board/olimex/imx233_olinuxino/readme.txt b/board/olimex/imx233_olinuxino/readme.txt index 2722c3acb..1e676c45d 100644 --- a/board/olimex/imx233_olinuxino/readme.txt +++ b/board/olimex/imx233_olinuxino/readme.txt @@ -27,73 +27,3 @@ Then, run the following command as root: *** WARNING! The command will destroy all the card content. Use with care! *** sudo dd if=output/images/sdcard.img of=/dev/<your-microsd-device> - -=== Manual creation of SD card image ========================================= - -You'll need a spare MicroSD card with Freescale's special partition layout. -This is basically three partitions: - -1) Type 53, the U-Boot partition, should be 16MB. -2) VFAT, place the kernel uImage there -3) Anything you like, for this example an ext2 partition, type 83 (linux). - -Assuming you see your MicroSD card as /dev/sdc you'd need to do, as root -and from the buildroot project top level directory: -(remember to replace /dev/sdc* with the appropiate device name!) - -***** WARNING: Double check that /dev/sdc is your MicroSD card ***** -***** It might be /dev/sdb or some other device name ***** -***** Failure to do so may result in you wiping your hard disk ***** - -1. Unmount the filesystem(s) if they're already mounted, usually... - - # for fs in `grep /dev/sdc /proc/mounts|cut -d ' ' -f 1`;do umount $fs;done - - ...should work - -2. Blank the partition table out - - # dd if=/dev/zero of=/dev/sdc bs=1024 count=1024 - -3. Set up the partitions - - # fdisk /dev/sdc - n - p - 1 - <ENTER> - +16MB - t - 53 - n - p - 2 - <ENTER> - +5M - t - 2 - 4 - n - p - 3 - <ENTER> - <ENTER> - w - -4. Fill up the first (U-Boot) partition - # dd if=output/images/u-boot.sd bs=512 of=/dev/sdc1 - -5. Create VFAT Filesystem - # mkfs.vfat /dev/sdc2 - -6. Mount and copy output/images/uImage.imx23-olinuxino to the VFAT partition, rename to uImage - # mount /dev/sdc2 /mnt - # cp output/images/uImages/uImage.imx23-olinuxino /mnt/uImage - # umount /mnt - -7. Fill up the third (filesystem) partition - # dd if=output/images/rootfs.ext2 of=/dev/sdc3 bs=512 - -8. Remove the MicroSD card from your linux PC and put it into your olinuxino. - -9. Boot! You're done! |