b43: Rewrite TX power adjustmentmaster-2008-08-29

This patch rewrites the TX power recalculation algorithms to scale better
with changed enviromnent. If there's low
TX traffic, the power will be checked against the desired values
every 60 seconds.
If there is high TX traffic, the check is redone every 2 seconds. This improves
the reaction times a lot and confuses the rate control less.
It will also reduce the time it initially takes to tune to a new TX power
value. With the old algorithm it could take about 30 to 45 seconds to settle to
a new power value. This will happen in about two to four seconds now.

Signed-off-by: Michael Buesch <mb@bu3sch.de>
Signed-off-by: John W. Linville <linville@tuxdriver.com>

1 files changed, 13 insertions, 5 deletions

diff --git a/drivers/net/wireless/b43/main.c b/drivers/net/wireless/b43/main.c
index af43f03b318..63bafc2f3f0 100644
--- a/drivers/net/wireless/b43/main.c
+++ b/drivers/net/wireless/b43/main.c
@@ -2805,6 +2805,9 @@ static void b43_periodic_every60sec(struct b43_wldev *dev)
 
 	if (ops->pwork_60sec)
 		ops->pwork_60sec(dev);
+
+	/* Force check the TX power emission now. */
+	b43_phy_txpower_check(dev, B43_TXPWR_IGNORE_TIME);
 }
 
 static void b43_periodic_every30sec(struct b43_wldev *dev)
@@ -2835,8 +2838,6 @@ static void b43_periodic_every15sec(struct b43_wldev *dev)
 	if (phy->ops->pwork_15sec)
 		phy->ops->pwork_15sec(dev);
 
-	phy->ops->xmitpower(dev);
-
 	atomic_set(&phy->txerr_cnt, B43_PHY_TX_BADNESS_LIMIT);
 	wmb();
 }
@@ -3382,10 +3383,13 @@ static int b43_op_config(struct ieee80211_hw *hw, struct ieee80211_conf *conf)
 
 	/* Adjust the desired TX power level. */
 	if (conf->power_level != 0) {
-		if (conf->power_level != phy->power_level) {
-			phy->power_level = conf->power_level;
-			phy->ops->xmitpower(dev);
+		spin_lock_irqsave(&wl->irq_lock, flags);
+		if (conf->power_level != phy->desired_txpower) {
+			phy->desired_txpower = conf->power_level;
+			b43_phy_txpower_check(dev, B43_TXPWR_IGNORE_TIME |
+						   B43_TXPWR_IGNORE_TSSI);
 		}
+		spin_unlock_irqrestore(&wl->irq_lock, flags);
 	}
 
 	/* Antennas for RX and management frame TX. */
@@ -3785,6 +3789,7 @@ static void setup_struct_phy_for_init(struct b43_wldev *dev,
 				      struct b43_phy *phy)
 {
 	phy->hardware_power_control = !!modparam_hwpctl;
+	phy->next_txpwr_check_time = jiffies;
 	/* PHY TX errors counter. */
 	atomic_set(&phy->txerr_cnt, B43_PHY_TX_BADNESS_LIMIT);
 }
@@ -4204,6 +4209,8 @@ static void b43_op_stop(struct ieee80211_hw *hw)
 		b43_wireless_core_stop(dev);
 	b43_wireless_core_exit(dev);
 	mutex_unlock(&wl->mutex);
+
+	cancel_work_sync(&(wl->txpower_adjust_work));
 }
 
 static int b43_op_set_retry_limit(struct ieee80211_hw *hw,
@@ -4581,6 +4588,7 @@ static int b43_wireless_init(struct ssb_device *dev)
 	INIT_LIST_HEAD(&wl->devlist);
 	INIT_WORK(&wl->qos_update_work, b43_qos_update_work);
 	INIT_WORK(&wl->beacon_update_trigger, b43_beacon_update_trigger_work);
+	INIT_WORK(&wl->txpower_adjust_work, b43_phy_txpower_adjust_work);
 
 	ssb_set_devtypedata(dev, wl);
 	b43info(wl, "Broadcom %04X WLAN found\n", dev->bus->chip_id);