1 files changed, 0 insertions, 58 deletions
diff --git a/board/gdsys/intip/intip.c b/board/gdsys/intip/intip.c
index b42e90853..23a10c41f 100644
--- a/board/gdsys/intip/intip.c
+++ b/board/gdsys/intip/intip.c
@@ -141,64 +141,6 @@ int checkboard(void)
 	return 0;
 }
 
-/*
- *  pci_target_init
- *
- *	The bootstrap configuration provides default settings for the pci
- *	inbound map (PIM). But the bootstrap config choices are limited and
- *	may not be sufficient for a given board.
- */
-#if defined(CONFIG_PCI) && defined(CONFIG_SYS_PCI_TARGET_INIT)
-void pci_target_init(struct pci_controller *hose)
-{
-	/*
-	 * Disable everything
-	 */
-	out_le32((void *)PCIL0_PIM0SA, 0); /* disable */
-	out_le32((void *)PCIL0_PIM1SA, 0); /* disable */
-	out_le32((void *)PCIL0_PIM2SA, 0); /* disable */
-	out_le32((void *)PCIL0_EROMBA, 0); /* disable expansion rom */
-
-	/*
-	 * Map all of SDRAM to PCI address 0x0000_0000. Note that the 440
-	 * strapping options to not support sizes such as 128/256 MB.
-	 */
-	out_le32((void *)PCIL0_PIM0LAL, CONFIG_SYS_SDRAM_BASE);
-	out_le32((void *)PCIL0_PIM0LAH, 0);
-	out_le32((void *)PCIL0_PIM0SA, ~(gd->ram_size - 1) | 1);
-	out_le32((void *)PCIL0_BAR0, 0);
-
-	/*
-	 * Program the board's subsystem id/vendor id
-	 */
-	out_le16((void *)PCIL0_SBSYSVID, CONFIG_SYS_PCI_SUBSYS_VENDORID);
-	out_le16((void *)PCIL0_SBSYSID, CONFIG_SYS_PCI_SUBSYS_DEVICEID);
-
-	out_le16((void *)PCIL0_CMD, in16r(PCIL0_CMD) | PCI_COMMAND_MEMORY);
-}
-#endif	/* defined(CONFIG_PCI) && defined(CONFIG_SYS_PCI_TARGET_INIT) */
-
-#if defined(CONFIG_PCI)
-/*
- * is_pci_host
- *
- * This routine is called to determine if a pci scan should be
- * performed. With various hardware environments (especially cPCI and
- * PPMC) it's insufficient to depend on the state of the arbiter enable
- * bit in the strap register, or generic host/adapter assumptions.
- *
- * Rather than hard-code a bad assumption in the general 440 code, the
- * 440 pci code requires the board to decide at runtime.
- *
- * Return 0 for adapter mode, non-zero for host (monarch) mode.
- */
-int is_pci_host(struct pci_controller *hose)
-{
-	/* Board is always configured as host. */
-	return 1;
-}
-#endif /* CONFIG_PCI */
-
 int board_early_init_r(void)
 {
 	/*