diff options
| -rw-r--r-- | arch/blackfin/include/asm/bfin_sdh.h | 31 |
1 files changed, 29 insertions, 2 deletions
diff --git a/arch/blackfin/include/asm/bfin_sdh.h b/arch/blackfin/include/asm/bfin_sdh.h index 6a4cfe2d3367..a99957ea9e9b 100644 --- a/arch/blackfin/include/asm/bfin_sdh.h +++ b/arch/blackfin/include/asm/bfin_sdh.h @@ -24,18 +24,27 @@ struct bfin_sd_host { #define CMD_INT_E (1 << 8) /* Command Interrupt */ #define CMD_PEND_E (1 << 9) /* Command Pending */ #define CMD_E (1 << 10) /* Command Enable */ +#ifdef RSI_BLKSZ +#define CMD_CRC_CHECK_D (1 << 11) /* CRC Check is disabled */ +#define CMD_DATA0_BUSY (1 << 12) /* Check for Busy State on the DATA0 pin */ +#endif /* SDH_PWR_CTL bitmasks */ +#ifndef RSI_BLKSZ #define PWR_ON 0x3 /* Power On */ #define SD_CMD_OD (1 << 6) /* Open Drain Output */ #define ROD_CTL (1 << 7) /* Rod Control */ +#endif /* SDH_CLK_CTL bitmasks */ #define CLKDIV 0xff /* MC_CLK Divisor */ #define CLK_E (1 << 8) /* MC_CLK Bus Clock Enable */ #define PWR_SV_E (1 << 9) /* Power Save Enable */ #define CLKDIV_BYPASS (1 << 10) /* Bypass Divisor */ -#define WIDE_BUS (1 << 11) /* Wide Bus Mode Enable */ +#define BUS_MODE_MASK 0x1800 /* Bus Mode Mask */ +#define STD_BUS_1 0x000 /* Standard Bus 1 bit mode */ +#define WIDE_BUS_4 0x800 /* Wide Bus 4 bit mode */ +#define BYTE_BUS_8 0x1000 /* Byte Bus 8 bit mode */ /* SDH_RESP_CMD bitmasks */ #define RESP_CMD 0x3f /* Response Command */ @@ -45,7 +54,13 @@ struct bfin_sd_host { #define DTX_DIR (1 << 1) /* Data Transfer Direction */ #define DTX_MODE (1 << 2) /* Data Transfer Mode */ #define DTX_DMA_E (1 << 3) /* Data Transfer DMA Enable */ +#ifndef RSI_BLKSZ #define DTX_BLK_LGTH (0xf << 4) /* Data Transfer Block Length */ +#else + +/* Bit masks for SDH_BLK_SIZE */ +#define DTX_BLK_LGTH 0x1fff /* Data Transfer Block Length */ +#endif /* SDH_STATUS bitmasks */ #define CMD_CRC_FAIL (1 << 0) /* CMD CRC Fail */ @@ -114,10 +129,14 @@ struct bfin_sd_host { /* SDH_E_STATUS bitmasks */ #define SDIO_INT_DET (1 << 1) /* SDIO Int Detected */ #define SD_CARD_DET (1 << 4) /* SD Card Detect */ +#define SD_CARD_BUSYMODE (1 << 31) /* Card is in Busy mode */ +#define SD_CARD_SLPMODE (1 << 30) /* Card in Sleep Mode */ +#define SD_CARD_READY (1 << 17) /* Card Ready */ /* SDH_E_MASK bitmasks */ #define SDIO_MSK (1 << 1) /* Mask SDIO Int Detected */ -#define SCD_MSK (1 << 6) /* Mask Card Detect */ +#define SCD_MSK (1 << 4) /* Mask Card Detect */ +#define CARD_READY_MSK (1 << 16) /* Mask Card Ready */ /* SDH_CFG bitmasks */ #define CLKS_EN (1 << 0) /* Clocks Enable */ @@ -126,7 +145,15 @@ struct bfin_sd_host { #define SD_RST (1 << 4) /* SDMMC Reset */ #define PUP_SDDAT (1 << 5) /* Pull-up SD_DAT */ #define PUP_SDDAT3 (1 << 6) /* Pull-up SD_DAT3 */ +#ifndef RSI_BLKSZ #define PD_SDDAT3 (1 << 7) /* Pull-down SD_DAT3 */ +#else +#define PWR_ON 0x600 /* Power On */ +#define SD_CMD_OD (1 << 11) /* Open Drain Output */ +#define BOOT_EN (1 << 12) /* Boot Enable */ +#define BOOT_MODE (1 << 13) /* Alternate Boot Mode */ +#define BOOT_ACK_EN (1 << 14) /* Boot ACK is expected */ +#endif /* SDH_RD_WAIT_EN bitmasks */ #define RWR (1 << 0) /* Read Wait Request */ |