diff options
Diffstat (limited to 'drivers/net/wireless/iwlwifi/iwl-core.h')
| -rw-r--r-- | drivers/net/wireless/iwlwifi/iwl-core.h | 79 |
1 files changed, 2 insertions, 77 deletions
diff --git a/drivers/net/wireless/iwlwifi/iwl-core.h b/drivers/net/wireless/iwlwifi/iwl-core.h index 6da53a36c1b..7bf76ab94dd 100644 --- a/drivers/net/wireless/iwlwifi/iwl-core.h +++ b/drivers/net/wireless/iwlwifi/iwl-core.h @@ -142,8 +142,6 @@ struct iwl_base_params { * @bt_init_traffic_load: specify initial bt traffic load * @bt_prio_boost: default bt priority boost value * @agg_time_limit: maximum number of uSec in aggregation - * @ampdu_factor: Maximum A-MPDU length factor - * @ampdu_density: Minimum A-MPDU spacing * @bt_sco_disable: uCode should not response to BT in SCO/ESCO mode */ struct iwl_bt_params { @@ -151,8 +149,6 @@ struct iwl_bt_params { u8 bt_init_traffic_load; u8 bt_prio_boost; u16 agg_time_limit; - u8 ampdu_factor; - u8 ampdu_density; bool bt_sco_disable; bool bt_session_2; }; @@ -165,77 +161,6 @@ struct iwl_ht_params { enum ieee80211_smps_mode smps_mode; }; -/** - * struct iwl_cfg - * @name: Offical name of the device - * @fw_name_pre: Firmware filename prefix. The api version and extension - * (.ucode) will be added to filename before loading from disk. The - * filename is constructed as fw_name_pre<api>.ucode. - * @ucode_api_max: Highest version of uCode API supported by driver. - * @ucode_api_ok: oldest version of the uCode API that is OK to load - * without a warning, for use in transitions - * @ucode_api_min: Lowest version of uCode API supported by driver. - * @valid_tx_ant: valid transmit antenna - * @valid_rx_ant: valid receive antenna - * @sku: sku information from EEPROM - * @eeprom_ver: EEPROM version - * @eeprom_calib_ver: EEPROM calibration version - * @lib: pointer to the lib ops - * @additional_nic_config: additional nic configuration - * @base_params: pointer to basic parameters - * @ht_params: point to ht patameters - * @bt_params: pointer to bt parameters - * @pa_type: used by 6000 series only to identify the type of Power Amplifier - * @need_temp_offset_calib: need to perform temperature offset calibration - * @no_xtal_calib: some devices do not need crystal calibration data, - * don't send it to those - * @scan_antennas: available antenna for scan operation - * @led_mode: 0=blinking, 1=On(RF On)/Off(RF Off) - * @adv_pm: advance power management - * @rx_with_siso_diversity: 1x1 device with rx antenna diversity - * @internal_wimax_coex: internal wifi/wimax combo device - * @iq_invert: I/Q inversion - * @temp_offset_v2: support v2 of temperature offset calibration - * - * We enable the driver to be backward compatible wrt API version. The - * driver specifies which APIs it supports (with @ucode_api_max being the - * highest and @ucode_api_min the lowest). Firmware will only be loaded if - * it has a supported API version. - * - * The ideal usage of this infrastructure is to treat a new ucode API - * release as a new hardware revision. - */ -struct iwl_cfg { - /* params specific to an individual device within a device family */ - const char *name; - const char *fw_name_pre; - const unsigned int ucode_api_max; - const unsigned int ucode_api_ok; - const unsigned int ucode_api_min; - u8 valid_tx_ant; - u8 valid_rx_ant; - u16 sku; - u16 eeprom_ver; - u16 eeprom_calib_ver; - const struct iwl_lib_ops *lib; - void (*additional_nic_config)(struct iwl_priv *priv); - /* params not likely to change within a device family */ - struct iwl_base_params *base_params; - /* params likely to change within a device family */ - struct iwl_ht_params *ht_params; - struct iwl_bt_params *bt_params; - enum iwl_pa_type pa_type; /* if used set to IWL_PA_SYSTEM */ - const bool need_temp_offset_calib; /* if used set to true */ - const bool no_xtal_calib; - u8 scan_rx_antennas[IEEE80211_NUM_BANDS]; - enum iwl_led_mode led_mode; - const bool adv_pm; - const bool rx_with_siso_diversity; - const bool internal_wimax_coex; - const bool iq_invert; - const bool temp_offset_v2; -}; - /*************************** * L i b * ***************************/ @@ -368,8 +293,8 @@ static inline const struct ieee80211_supported_band *iwl_get_hw_mode( static inline bool iwl_advanced_bt_coexist(struct iwl_priv *priv) { - return priv->cfg->bt_params && - priv->cfg->bt_params->advanced_bt_coexist; + return cfg(priv)->bt_params && + cfg(priv)->bt_params->advanced_bt_coexist; } static inline void iwl_enable_rfkill_int(struct iwl_priv *priv) |